General Description:

A cloudy, plastic, Stacked-cylindrical bubbler that is commonly used by placing it at the top of a fermenter in a hole, tightening the nut from the bottom and filling it with water, sanitizer solution or alcohol.

The purpose of this device is to allow CO2 to escape whilst preventing oxygen, bacteria and wild yeast from entering the fermenter due to positive pressure and stacked design that is filled with liquid.

Dimensions:

36cm height

12cm diameter

Installation instructions:

Drill a 45mm hole in the top/lid of your fermenter, place the threaded end of the bubbler into the hole until the seal is resting on the surface of the lid. Screw on the nut of the bubbler onto this thread until it is on tightly to create an airtight seal.

Disclaimer:

This is a fairly large bubbler and is recommended for use with large plastic tanks and I.B.C.s.

This bubbler is rated for fermentation tanks that are 250L+ in volume.