General Description:

Gen 3 Cooling Coil for cooling Gen 3 pressure fermenters. This Cooling Coil will attach to our Fermenter King Lids. 

The coil is constructed of 304 stainless steel 8mm tubing and there are 4 coils in base.

Coils are offset so they will not impeded the operation of the plunge valve or centralised floating liquid pick up tube of the Fermenter King vessels. 

Dimensions:

54cm long

Installation:

To install, simply drill two 12.8mm holes in the expansion ports of your Fermenter King lid to accommodate the bulkheads of the cooling coil. 

Insert the threaded bulkheads through the holes using the silicone o-rings to create a seal on the underside of the lid. The threaded bulkheads will protrude through the lid and can be held tight by the hex nuts on the exterior of the lid.

Once positioned, the coils in the tank can be slightly separated to increase the contact area with the liquid.

This unit can be used to both cool and heat your brew in any of the Gen 3 pressure fermenters by running water or a glycol solution through it.