General Description:

A sturdy, dual guage regulator that is commonly used to regulate the pressure of CO2 in kegs for carbonation.

Usage Instructions:

Assemble the regulator by loosely attaching the knob to the top of the regulator – do not tighten the knob, it should be loose fitting at this point as this will keep the regulator closed.

Connect the CO2 regulator to the CO2 cylinder by tightening the type 30 CO2 not on the male thread of the cylinder.

Connect the gas line to the regulator by pushing it over the hose barb or into the 3/8 to 7/16 UNS connector that replaced it.

Connect the line to the keg by using the correct ball lock fitting.

Raise the pressure of the keg by slowly tightening the knob at the top of the regulator until the desired pressure is reached.

Release pressure from the keg by pulling the Pressure Relief Valve on the side of the regulator.